This study examined the effects of sulfuric acid concentrations on the corrosion behaviors of three types of commercial steels, conventional carbon steel (SA192), sulfuric acid dew resistant steel (S-TEN), and duplex stainless steel (S32205), considered to be potential materials for the heat recovery steam generator (HRSG) in combined cycle power plants. Based on the results of electrochemical polarization, immersion and wet-dry cycle tests, when exposed to a high sulfuric acid concentration (50%), SA192 and S-TEN exhibited higher corrosion resistance than S32205, which was due to the formation of a stable FeSO₄ scale on the carbon steel materials. With prolonged exposure, S-TEN with slightly higher concentrations of Cu and Sb showed lower weight loss than SA192. Conversely, when subjected to low sulfuric acid concentrations (5 and 10%), S32205 exhibited passivation behavior, and showed significantly superior corrosion resistance (i.e., much smaller weight loss) than the other two steel samples. The examination of localized corrosion damages through cross-section observation using a scanning electron microscope revealed also that S32205 suffered less damages from the wet-dry cycling. The long-term superior corrosion resistance of duplex stainless steel in low sulfuric acid concentrations, compared to carbon steel and sulfuric acid due resistant steel, make it a promising candidate material for the HRSG in combined cycle power plants. (Received 9 June, 2023; Accepted 18 July, 2023)