The purpose of this study was defined effcient throw motion pattern to obtain the quantitative data and to achieve successful bowling through kinematic variables on the throw motion. Subject of group composed of two group : Higher bowlers who are two representative bowlers with 200 average points and one pro-bowler. Lower bowler who are three common persons with 150 average points. Motion analysis on throw motion in two groups respectively has been made through three-dimension cinematography using DLT method. Two high-speed video camera at operating 180 frame per secondary. One-way ANOVA has been used to define variable relations. Analyzed result and conclusion are the following : The displacement of the finger tip must have less difference of each right-left displacement to make a stabler throw. In case of the high bowlers, the frontal-rear displacement in three phases has become faster to increase linear momentum. In contrast, in case of failure it become slower. To make a strong lifting the velocity of the vertical direction of the finger tip has shown the wider range in its accelerated velocity. The suddenly increased velocity of the frontal-rear direction in follow through has advantageously operated to increase the momentum of the ball. The angle of the back of the hand should be acute as possible. Acutely flexing the angle of the back of the hand has contributed to lifting to increase the spin of the ball. In the release step, wrist should be flexed as much as possible, when the angle of the wrist is acute, the spin of the ball tend to increase. To increase the momentum, the angle difference the shoulder in each stage should be wide.