To improve the reliability of solder joints, a composite solder which consists of solder matrix and intermetallic reinforcerants was manufactured by a new method. The cast ingot of Sn-6.9Cu-2.9Ag alloy had primary Cu6Sn5 intermetallics in the form of dendrites. After rolling the ingot, the intermetallic dendrites were crushed into fine particles and distributed uniformly throughout the solder matrix. As the rolled strips became thinner, the average size of the crushed particles reached a critical size which did not decrease any more by further rolling. The critical size was nearly the same as the average width of intermetallic dendrite trunk The crushed intermetallic particles did not melt and remained in solid state during reflow soldering due to their high meltingernperature. The coarsening and gravitational segregation of the particles were observed during reflow soldering.